Rollenklischees essay. Iphone 5s logic board beschreibung. Aufsatz auf englisch

lower antenna connector up off its socket on the logic board. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured. Doing so may tear the

cable. Some devices may have two screws, one of which holds down the contact pad which is located above the screw indicated in red in the photo. This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless. Before reassembly, be sure to clean all metal-to-metal contact points on the dock connector cable cover with a de-greaser such as windex. The "blurrycam" images, shared by, macRumors, don't reveal much in the way of new features or components, though this is to be expected as many believe Apple's next-generation iPhone will carry over the design of the current iPhone. This is certainly not the first time we have seen the iPhone 5S rear shell. It should be noted that an overlay of the the two image does not yield a perfect match, though it is plausible that the disparity can be accounted for by Apple's cable routing. Edit Remove the.9 mm Phillips screw securing the bottom of the logic board to the inner case. Remove the metal clip covering the antenna connector. Remove the.4 mm Phillips screw that was hidden underneath the sticker. It appears that the iPhone 5S, rumored for release around September of this year, will be no different in that regard, although many specific details on the internals of the device have yet to be revealed given that the logic board leaked earlier today does. This corresponds to the logic board seen in the photos earlier today, with a vertical connector near the top inside edge of the board and a horizontal one along the top edge. Make sure you don't lose the metal clips on the top of the cover where the.8mm screw attaches or the.8mm screw. When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place. This is the ground for the Wi-Fi antenna and is often the culprit if you are having bad Wi-Fi reception after reassembly. Another interesting tidbit in this report is that the website also has taken a closer look at the Home button area.

Edit Pinch the rear panel with your fingers and lift it away from the iPhone. Before reassembly, both the LCD and digitizer cables should be immediately next to one another and should be the same length. Unlike the iPhone 5, be sure the four small EMI fingers rest below the lip of the LCD frame. Be beschreibung careful not to trap the lower antenna cable beneath the logic board.

Coming on the heels of images purporting to show the logic board of the next-generation iPhone 5S, photos alleging to be of the handset s display have surfaced, with.Canaccord Genuity analyst Michael Walkley has raised his price target for Apple stock from 560 to 580, based on expectations for the iPhone 5s, the.Earlier today, we noted that photos of what was claimed to be the bare logic board of the iPhone 5S had surfaced, showing some changes to the.

Doing so may result In damage to the digitizer cable. S display, carefully pry the upper edge of the front panel assembly away from the steel inner frame. If the home button sticks to the front panel you may tear the home button cable. T as much of an overhang on the sides. T slip and damage surrounding components, this can prevent several issues and simplify troubleshooting. Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle. Deutsch, there is one item of interest supporting the claim that introduction the logic board photos from earlier today are genuine. Please click here for the new version of this guide. Français, an analyst predicted that the fingerprint sensor will only be used for user authentication.

 

IPhone 5S, display Assembly Surfaces, Appears to Fit

If you pry up on the logic board socket, you may break it entirely.Before reassembly, be sure to clean all metal-to-metal contact points between the EMI fingers and the internal frame as well as the brass screw mounting point with a de-greaser such as Windex.Also make sure to put the long.8 mm Philips back in correctly when reassembling.”